avital 4103 db all 02 grand cherokee
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136027
Printed Date: July 02, 2025 at 12:50 AM
Topic: avital 4103 db all 02 grand cherokee
Posted By: mainer
Subject: avital 4103 db all 02 grand cherokee
Date Posted: February 08, 2014 at 11:38 PM
I have a 2002 Jeep Grand Cherokee Overland (limited)
It is equipped with the following:
* Factory Alarm
* Chipped Key
I have an Avital 4103 with a DB-All connected via D2D and am having an issue where it will not stay running for the set amount of time which is 24 minutes. It will run anywhere from 5-13 minutes. When it stops running prematurely it Will Not attempt to restart. It will not allow me to restart via remote start unless I start the Jeep and put it in gear, return to park and then turn it off. In doing so it will then again allow me to use the remote start.
I have checked the grounds. I have run diagnostics on the Avital and I get the following. 6 flashes = (+) Shutdown (H3/3 BROWN)
On the DB-ALL when the remote start is running, the LED is a constant Green Flash
Flashes Green
Flashing green continuously
Ground While Running (status) on.
Ground While Running signal has been lost or was never detected by the module. Refer to the wiring diagram to make sure the connections are correct. If in D2D, make sure the remote starter is engaging the remote start sequence.
Any help and or guidance would be appreciated!
Replies:
Posted By: freqsounds
Date Posted: February 09, 2014 at 10:54 AM
Jeeps really don't like the Smart OEM Alarm Control. I recommend putting the setting in Normal or Disabled (preferred) and not lock with the factory fob. This feature has caused me more grief than good. Might be worth a shot.
-------------
No question is stupid or not worth asking. You were once a noob, right? :)
Posted By: mainer
Date Posted: February 09, 2014 at 11:31 AM
freqsounds wrote:
Jeeps really don't like the Smart OEM Alarm Control. I recommend putting the setting in Normal or Disabled (preferred) and not lock with the factory fob. This feature has caused me more grief than good. Might be worth a shot.
Thanks!
Are these settings for the DB-ALL? Or the Avital?
Posted By: freqsounds
Date Posted: February 09, 2014 at 11:34 AM
This is a setting in the DBALL. I think feature 4 if memory serves.
-------------
No question is stupid or not worth asking. You were once a noob, right? :)
Posted By: mainer
Date Posted: February 09, 2014 at 11:46 AM
freqsounds wrote:
This is a setting in the DBALL. I think feature 4 if memory serves.
Great! Thanks again. I will update when I get a chance to work on it.
|