Print Page | Close Window

dei 507m digital tilt sensor

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136069
Printed Date: April 27, 2024 at 12:29 PM


Topic: dei 507m digital tilt sensor

Posted By: godd dan it
Subject: dei 507m digital tilt sensor
Date Posted: February 15, 2014 at 2:17 PM

Its been awhile since I have installed one of these. What is the best settings for this?

Also, do you recommend installing a diode just incase it doesnt "falsely" trip the alarm?

Thanks.

-------------



Replies:

Posted By: godd dan it
Date Posted: February 17, 2014 at 10:03 PM
Anyone?

-------------



Posted By: freqsounds
Date Posted: February 24, 2014 at 9:13 AM
It shouldn't need a diode at all.

The best way to test these is to install it to a hard surface that doesn't move (i.e. the steering column) and rock the car. You want to make sure the wind doesn't set it off. If a slight rock sets the alarm off, cut the black wire loop on the 507m. This will change the setting from the 1º threshold to 3º.

-------------
No question is stupid or not worth asking. You were once a noob, right? :)


Print Page | Close Window