xpressstart one unlock before start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136073
Printed Date: September 13, 2025 at 2:22 AM
Topic: xpressstart one unlock before start
Posted By: dustintinsley
Subject: xpressstart one unlock before start
Date Posted: February 15, 2014 at 10:45 PM
Installed a XpressStart One in a '14 Tundra. The unlock feature will not work while the remote start function has been triggered. Is there a way in the settings to either make it automatically unlock before starting or to enable the unlock function while the truck is running?
Replies:
Posted By: freqsounds
Date Posted: February 24, 2014 at 9:31 AM
Try this:
POWER LOCK WHITE (TYPE B) in DRIVERS KICK PANEL, (BLUE, 17-Pin Plug) Pin 7
**Connect pin 15 on the 18 pin white connector on the XpressStart One to this wire**
POWER UNLOCK RED (TYPE B) in DRIVERS KICK PANEL, (BLUE, 17-Pin Plug) Pin 6
**Connect pin 7 on the 18 pin white connector on the XpressStart One to this wire**
I would meter the wires above to make sure they 'light up' when you press the lock/unlock button on the door.
This is using XpressStart One's lock/unlock output wires to override the CAN message sent to the BCM.
-------------
No question is stupid or not worth asking. You were once a noob, right? :)
|