wiring for 2010 sprinter van
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136085
Printed Date: May 23, 2024 at 11:04 AM
Topic: wiring for 2010 sprinter van
Posted By: allsound
Subject: wiring for 2010 sprinter van
Date Posted: February 17, 2014 at 1:06 PM
I'm looking for wiring information to do an alarm install on a 2010 Freightliner Sprinter van
-------------
Quinn Maxwell
Replies:
Posted By: harryharris
Date Posted: February 17, 2014 at 1:14 PM
If this is the same as the European Mercedes Sprinter, use DB-ALL wired D2D, everything on that vehicle is easy to get at, siren and hood switch wire back through grommet, pick up corner loom for 12V+ and ground, CAN Hi and Lo, run antenna and lead, connect and initialise DB-ALL, then if you want, program DB-ALL for window up down.
All done, I love em!
So much easier than the hardwiring required on the pre-07 version.
-------------
Test before boxing up.
Posted By: allsound
Date Posted: February 17, 2014 at 1:24 PM
The wiring info I need is the stock wire colors on the ignition harness, etc. I have the clifford alarm system ready to go, I just need the vehicles wiring diagrams
-------------
Quinn Maxwell
Posted By: harryharris
Date Posted: February 17, 2014 at 4:03 PM
Don't use the ignition wires all you'll have there are ignition 1 and 2 and ACC the starter wire is in the engine bay loom (violet).
If this is a late Clifford with a brown data port use a DB-ALL so much easier.
If an R/S you will need another part from Xpresskit.
-------------
Test before boxing up.
|