2011 chevy traverse dball2 issue

I just installed a avital 4103 in a 2011 traverse using a dball2 bypass. Hooked it up using installation type 1 with rf loop. Flashed it with the latest firmware, hooked it up d2d and did the learn routine. When you press the remote start, you can hear the remote start module kick on and the relays click but nothing lights up on the dash and it does not start, the car doesn't do anything. I press the lock and unlock buttons on the remote and you can hear it click in the remote start module but the car does nothing. I'm thinking that its something with the dball2. Anyone out there have experience with this? any help or ideas would be greatly appreciated.

Hey, I have been reading alot about issues with avital and d2d. Seems like the d2d does not like to work too often and almost never with a dball module. I ran across some sweet info, which i will post at the end. So long story short, the avital unit was shipped in bitwriter mode not d2d mode. All I had to do was program the avital for d2d instead of bitwriter, everything works great now. Heres the info I found.

Directed Avital d2d issues with xpresskit DBALL fix
Older Avital units (11K date code and older) Hardwire power and ground for the DB ALL.

Newer Avital (11Kand Newer) Unit comes shipped in bitwriter mode must :
power down unit
Ground white and blue slave start (trigger start ) wire
Power up unit
Led will flash 5 times to confirm d2d mode
Remove ground from white and blue wire

That's exactly what I was going to suggest. Great work! Glad it worked out.

-------------
No question is stupid or not worth asking. You were once a noob, right? :)