Print Page | Close Window

icbm 7071 remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136177
Printed Date: May 07, 2025 at 12:38 AM


Topic: icbm 7071 remote start

Posted By: antman1
Subject: icbm 7071 remote start
Date Posted: February 27, 2014 at 3:34 PM

I installed this alarm in 2012 in my 2000 Chrysler Town and Country and it worked great until just after Summer of 2013. The alarm is working flawlessly however the remote start cranks the after a few seconds turns off then tries 2 more times repeating the procedure to try and crank. It gets cranked but acts like it cant see the tach signal. I tried disconnecting the tach wire from were I had it and it was working then connected it to an injector. Both connections appear fine with tach signal. I followed the tach wire and tested for continuity and it is fine as well. I was wondering if it would be ok to use the red wire from the diagram on the alarm to connect to any 12v constant and if the would work instead of the tach wire? Below is the part of the wiring diagram I am talking about.
https://home.comcast.net/~antman1455/wiring1.jpg

and here is the entire manual for the alarm/remote start:
PerformanceTekniqueUserManual-ICBM7071

Any help is much appreciated. Thank you.



Replies:

Posted By: antman1
Date Posted: March 04, 2014 at 1:10 AM
I wrote the "red wire" but meant "BLACK/ White" wire for a 12v constant. Anyone know how I can make this work?


Print Page | Close Window