smart start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136287
Printed Date: April 28, 2024 at 4:51 PM
Topic: smart start
Posted By: wfd410
Subject: smart start
Date Posted: March 17, 2014 at 3:29 PM
I have a Viper 5906v with the DBall2 D2D in my 2006 Honda Accord. I am adding a viper vsm250 Smart Start. When installing the VSM250 I connected the black pin into the bitwriter port, connect the red wire to power, the black wire to ground, the gray wire to ground and the didn't do anything with the white wire. I get a solid orange light but no green light at all.
Replies:
Posted By: harryharris
Date Posted: March 17, 2014 at 4:17 PM
Start again this time don't connect the gray wire.
-------------
Test before boxing up.
Posted By: wfd410
Date Posted: March 17, 2014 at 4:41 PM
That worked. You are a freakin genius. Thank you.
Posted By: harryharris
Date Posted: March 17, 2014 at 4:57 PM
Funnily enough I've never even bothered with the gray wire, I usually install 5X04 units, always do the Smartstart last and the only time I ever had a problem was a guy who upgraded the OS on his iPhone, I made him dump the APP and reload it, bingo!
-------------
Test before boxing up.
Posted By: tommyjerzboy
Date Posted: February 28, 2015 at 1:48 AM
Can I ask where exactly is everyone connecting the red & black wire to? I know to power & ground but where exactly sorry if it sounds like a dumb question I'm installing a SmartStart for the first time. Thank you in advance
Posted By: howie ll
Date Posted: February 28, 2015 at 2:51 AM
The 15 amp RED at H1 (before that fuse) and a 3 amp fuse for the SmartStart plus the black at H1.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: tommyjerzboy
Date Posted: March 03, 2015 at 8:47 AM
Thanks guys spliced it into the Red in H1 and grounded the black to chasis, first problem for some reason was all the warning lights came on, then they went away by themselves, only engine code light that's on now on the dtc report is U1411 Implausible Fuel Volume Signal, I cleared it and it comes right back on, also after I got it all working yesterday, waking up today and trying to start the jeep from the SmartStart app I keep getting an error box pop up on the app stating the request has timed out (51) any help on these issues would be appreciated thank you in advance
Posted By: tommyjerzboy
Date Posted: March 03, 2015 at 1:36 PM
Well drove it around a few times and seems it corrected itself hopefully
|