211hv in a 2005 nissan altima
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136297
Printed Date: April 19, 2024 at 12:50 PM
Topic: 211hv in a 2005 nissan altima
Posted By: downsouthplaya
Subject: 211hv in a 2005 nissan altima
Date Posted: March 19, 2014 at 10:54 AM
Hey guys, its been a while since I last worked on anything (almost 15 years) and my circuit city 12volt memory is not what it use to be :)
I have a 2005 Nissan Altima that I want to install a Viper 211HV keyless entry I found cleaning out some boxes.
My Nissan has the driver and passenger anti-pinch windows. If my memory serves me correct that matters as far as the doorlocks are concerned. I vaguely remember using the factory disarm on a short double pulse to lock the door and using the same wire for the factory disarm.
I believe I would also only be using the lock and unlock common wires on the 211HV.
Its been a long time, if anyone can assist and confirm or deny my suspicions I'd greatly appreciate it.
Replies:
Posted By: Twelvoltz
Date Posted: March 24, 2014 at 12:35 PM
There are differences as to where you can and can't grab lock/unlock wires in that 05 Altima. And as you said, it depends on whether or not you have just anti-pinch on the driver's door or on both doors. However instead of worrying about that, regardless of anti-pinch in you vehicle, you can get arm/lock and disarm/unlock at the BCM in 2 empty pins. I took this information from IDatalink's installation manual for that car...
Lock/Arm M18 White 40 pin 08 Empty(-)
Unlock/Disarm M18 White 40 pin 07 Empty (-)
Located at BCM left of steering column
You would provide negative pulses to empty slot at pin 08 to lock/arm and to pin 07 to unlock/disarm.
-------------
Installer, IT support, and FFL. I need less hobbies.
|