cm6000 remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136365
Printed Date: May 02, 2024 at 6:03 AM
Topic: cm6000 remote start
Posted By: qpham504
Subject: cm6000 remote start
Date Posted: March 31, 2014 at 10:09 AM
Hey guys,
So I got my ft6000as installed and confirmed that the remote start function worked with and without the blade. I finished the install by hiding all wiring within looms and cleared everything up. I was trying to program the double pulse and the one way remotes are clunky and the instructions were clunky. So fast forward I think I might have programmed something wrong and now when it remote starts it immediately shuts off. No warning lights or anything and it doesn't attempt to start again either. Any clues?
Also can someone assist me on what I need to do to program. When getting to the part where I press the trunk and key to scroll do I still have to wait 2.5 seconds to release? Still working this right now. I am glad I'm done with the install because it was a pain.
Replies:
Posted By: blanx218
Date Posted: March 31, 2014 at 3:24 PM
What kind of car?
Posted By: qpham504
Date Posted: March 31, 2014 at 3:27 PM
Found the problem, it looks like there was static ground noise coming in from the glass breaking sensor. Judging by the route I used to run it the issue could be coming from the amp installation from previous owner or ground noise coming from the speaker wires running along the same route. For now I've unplugged the glass sensor until I can figure out how to handle this situation.
|