viper 5704v on a 01 honda civic
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136446
Printed Date: April 26, 2024 at 1:26 PM
Topic: viper 5704v on a 01 honda civic
Posted By: boricua bob
Subject: viper 5704v on a 01 honda civic
Date Posted: April 14, 2014 at 11:50 AM
i have a 01 honda civic ex and i am trying to install a viper 5704v remote start. i have the alarm working except the parking lights and the remote start. this is what iv done so far...any help will sure be appreciated... thanks
6pin connector
h1/1 red to 12v white@ign
h1/2 black to chassis ground
h1/3 brown to siren(+)
h1/4 WHITE/ brown didn't use
h1/5 white to RED / black @ back of fuse box
h1/6 orange didn't use
door lock 3pin
1 blue to WHITE/ green
2 empty
3 green to WHITE/ blue
24 pin connector
1-8 didn't use
9 gray to hood pin (haven't connected yet
10 blue to RED / 2 sil. dots
11 didn't use
12 violet/white haven't connected yet to tach
13 BLACK/ white to chassis ground
14 did't use
15 green to green drivers door & lt.GREEN/ red passenger door &GREEN / WHITE both rear doors
16 BROWN / black to ORANGE / 2 sil. dots
17-19 didn't use
20 brown to WHITE/ black brake pedal
21-24 didn't use
remote start 10 pin
h3/1 pink to BLACK / YELLOW ign.
h3/2 RED / white to BLACK/ red ign.
h3/3 orange to WHITE/ red acc.
h3/4 violet to BLACK/ white starter going to car side
h3/5 green to BLACK/ white starter going to key side
h3/6 red to white 12v @ign.
h3/7 pink/white to BLACK/ red ign.
h3/8 didn't use
h3/9 RED / black to WHITE/ red acc.
h3/10 not used
Replies:
Posted By: boricua bob
Date Posted: April 14, 2014 at 1:36 PM
i connected the h1/5 white wire (parking light output) first to the blue wire parking ligh(-)located on the ign. switch harness and didn't work then a connected it to the RED / black wire(+) in harness clip next to the fuse box and it still doesn't work. please help. also the remote start doesn't do anything all i here is the alarm brain flixer like six times and the alarm remote say remote start error...
Posted By: harryharris
Date Posted: April 14, 2014 at 4:05 PM
H3/RED / white to white constant please.
Did you insert then change the polarity control 10amp fuse in the alarm brain, i.e. set NEG (-) to blue wire or set POS (+) to RED / black?
-------------
Test before boxing up.
Posted By: boricua bob
Date Posted: April 14, 2014 at 5:04 PM
no i just changed the h1/5 white wire and tried it on the blue first and then the RED / black and nothing..
Posted By: boricua bob
Date Posted: April 14, 2014 at 8:12 PM
i did the fuse on the brain and it work the parking lights now work with the alarm. thanks. i also connected the H3/RED / white wire to white constant and still the same i get remote start error on the remote and the lights flicker 7 times. desperately need help. thanks
Posted By: kreg357
Date Posted: April 14, 2014 at 9:11 PM
Seven Blinks = Manual Transmission Mode
If your Civic has an automatic transmission, program the Viper to Auto Trans - Menu 3, Item 1, Option 2.
You listed H2/2 BLACK/ WHITE (-) NEUTRAL SAFETY INPUT as not used. It should be connected as follows :
With Auto Trans = Chassis Ground
With Manual Trans = Parking Brake (-) ------------- Soldering is fun!
Posted By: howie ll
Date Posted: April 14, 2014 at 10:14 PM
I have to say both of your problems are RTFM linked.
Does this vehicle have an immobiliser?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: boricua bob
Date Posted: April 14, 2014 at 10:33 PM
thanks kreg357 it work. it remote started with the key in the ign.
i also connected this to 12v constant
h3/2
h3/6
h3/9
now i can connect the 555i. is there a diagram or something showing how to connect this. where i can find a diagram to find which wires are located on my car.
thanks u guys for all ur help....
Posted By: howie ll
Date Posted: April 14, 2014 at 10:40 PM
Yes in the box that the 555i came in, again all related to RTFM.
Please read the last line on my signature.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: kreg357
Date Posted: April 15, 2014 at 6:11 AM
Here is a link to the 555i install guide, in case yours' is lost. https://www.the12volt.com/installbay/file.asp?ID=1269
As for the Civic's wires, here is some info from iDatalink :
Ignition ~ ~ Pin 6 Yellow/Black (+) @ Ignition switch transponder plug
Data ~ ~ Pin 2 RED / Blue (DATA) @ Ignition switch transponder plug
Keysense info from ReadyRemote :
Keysense RED / white (-) @ factory alarm plug above driver kick, green 16 pin plug, pin 12
The 555i Blue R/S Input wire connects to the Viper 5704 Dark Blue (-) 200mA Status Output. ------------- Soldering is fun!
Posted By: boricua bob
Date Posted: April 15, 2014 at 7:17 AM
Thanks kreg357 I'll install it later in the afternoon. U been a big help.
Posted By: boricua bob
Date Posted: April 15, 2014 at 4:27 PM
thanks again. i finished the install. everything works great...u been a big help..
Posted By: kreg357
Date Posted: April 15, 2014 at 5:41 PM
Alright, good job .  Just in time for the hot weather! ------------- Soldering is fun!
|