car would not turn off
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136540
Printed Date: May 03, 2024 at 2:44 PM
Topic: car would not turn off
Posted By: sabarni
Subject: car would not turn off
Date Posted: April 29, 2014 at 10:08 AM
I just finished installing a Viper 5704 + Dball, firmware Mazda 1.10.14, on a 2009 Mazda 6 push button start, but I can’t turn off the remote start with the transmitter once is started, and is set for 12 min runtime, even after the time expired the car is still running and I’m getting an alert “key is on”. Do you guys have any suggestion why is this happening?
Replies:
Posted By: racerjames76
Date Posted: May 07, 2014 at 9:47 AM
Have not used that hardware on that car but it obviously sounds like either the dball is not turning off after shutdown or there is a data problem and the dball is not pulsing the PTS to turn the car off..
-------------
To master and control electricity is perfection. *evil laugh*
Posted By: Ravendarat
Date Posted: May 08, 2014 at 7:06 PM
Uh your key isn't near the vehicle when you are trying this are you?
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: sabarni
Date Posted: May 12, 2014 at 10:11 AM
racerjames76 wrote:
Have not used that hardware on that car but it obviously sounds like either the dball is not turning off after shutdown or there is a data problem and the dball is not pulsing the PTS to turn the car off..
I did talk to tech support, and apparently there is a new install and firmware for this car because the older version was "buggy", so I did change the few wires as per new diagram the Rx does not needs to be cut so I soldered back and removed the unnecessary wires, I will try to load the new firmware hopefully would help. I will post back once I'm done with the flash. Btw any of you had a same setup/car installation?
Posted By: racerjames76
Date Posted: May 12, 2014 at 10:41 AM
Still not sure what your issue is, but I am wondering if a simple pulse from the shut down wire or factory alarm rearm wire to the PTS wire would shut it down properly?
-------------
To master and control electricity is perfection. *evil laugh*
Posted By: sabarni
Date Posted: May 13, 2014 at 12:10 PM
So I did the software flash, and did help the car starts up and I can turn it off with the remote also I hooked up the windows+sunroof and does work, but there is still an issue the car not always starts up, fails to crank or cranks just a little bit, any thoughts?
|