2014 dodge durango security/rs dball2

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136563
Printed Date: May 14, 2024 at 4:24 PM

Topic: 2014 dodge durango security/rs dball2

Posted By: shadowinfector
Subject: 2014 dodge durango security/rs dball2
Date Posted: May 04, 2014 at 11:06 PM

trying to finish an install on a 14 dodge Durango push start with the dball2.....The instructions state I can use KEY2GO with 1 key (I don't have dealer access) or I can use 2 key programming, but i don't see any instructions for them. DOes anyone know if i need to use the KEY2GO? if i do any fellow installer wanna help me out with a login so i can complete my install> posted_image

....or any other solution>? thanks

Replies:

Posted By: shadowinfector
Date Posted: May 04, 2014 at 11:24 PM

also this car did not have factory security. while installing there was no driver door pin on the bcm white connector nor was there a WHITE/ brown parking light (mux) wire in the blue connector.....did I miss something or has anyone ran into this before?

Posted By: shadowinfector
Date Posted: May 05, 2014 at 8:49 AM

anyone?

Posted By: triniforever
Date Posted: May 06, 2014 at 8:11 AM

Did you look for the negative parking light wire? But it must be relay isolated with a resistor ! Also most parking light wire can be found in the harness running to the rear of the vehicle in the drivers running board.

-------------
triniforever

Posted By: shadowinfector
Date Posted: May 11, 2014 at 3:32 PM

thanks for the reply....i just went off the tech sheet and tested the wires....got the key2go programmed and all set now.

Print Page | Close Window