compustar cm7000 blade al tach error
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136625
Printed Date: April 29, 2024 at 11:09 AM
Topic: compustar cm7000 blade al tach error
Posted By: kyousif
Subject: compustar cm7000 blade al tach error
Date Posted: May 11, 2014 at 10:24 PM
I just finished installing a Compustar CM7000 with Blade-AL on a 2008 Nissan Sentra with intellikey.
Latest Firmware updated on brain v2.12
Idatalink flashed to NI4 using type 3 wiring diagram. Will not crank on remote start then get error code 8
I'm assuming I have a problem. I tried to do tach learn seemed to take it.
Any ideas or suggestions much appreciated
Ken
Replies:
Posted By: kyousif
Date Posted: May 11, 2014 at 10:26 PM
Assuming programming problem. Typo from above
Posted By: enice
Date Posted: May 13, 2014 at 2:30 PM
did you cut the loop inside the brain? Assuming it is an automatic.
------------- Eric
Audiomaxx
528 East Fordham Road
Bronx NY 10458
Compustar Top Gun Dealer Award 2012-2013
Posted By: kyousif
Date Posted: May 13, 2014 at 6:29 PM
Yes thank you.
Luckily it was my sons car. I had to work on it in 4 different sessions over a week.
It's done it works. I reflashed the blade-al. and I caught the wrong 2 wires for Data Clock and Data Immobilizer. GOOD thing I didnt fry something. Next time I leave it for the professionals.
Ken
|