another dei 530t issue, 2007 yaris

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136722
Printed Date: May 13, 2025 at 6:25 PM

Topic: another dei 530t issue, 2007 yaris

Posted By: kaeon
Subject: another dei 530t issue, 2007 yaris
Date Posted: May 30, 2014 at 7:32 AM

I have a 2007 Toyota Yaris Hatch that I just installed a 530T on and I am having a problem. The driver window works absolutely fine going up and down. However the passenger side goes down maybe halfway at the first click of the cars interior switch. I then have to click the interior switch a few more times to get it to go down all the way. I read up on the issue a little bit and greased the tracks, but that didn't help much. I hear about doing a resistor mod via the 1900 doc. However I am unsure which version I have.

posted_image

Replies:

Posted By: howie ll
Date Posted: May 30, 2014 at 9:26 AM

Did you wire the passenger door from the driver's switch or did you go into each door?
The second answer is the only way to go.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: kaeon
Date Posted: May 30, 2014 at 2:11 PM

howie ll wrote:

Did you wire the passenger door from the driver's switch or did you go into each door?
The second answer is the only way to go.

Everything is wired to the drivers door master switch.

Posted By: howie ll
Date Posted: May 30, 2014 at 5:46 PM

Follow the instructions and place the unit in the middle of the car then wire directly to each motor.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.