2011 lancer fast key
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136894
Printed Date: May 16, 2024 at 11:35 PM
Topic: 2011 lancer fast key
Posted By: lilancer
Subject: 2011 lancer fast key
Date Posted: June 30, 2014 at 11:42 AM
Hi I have a 2011 lancer gts with fast key. I have Installed a viper 5904 using flcan Using D2D, so the viper arms and disarms off the factory remote. I also want to be able to remote start off the factory remote as well. I know that the input activation wire needs to be wired for this to happen. If I wire the input activation to the cars lock wire I can remote start the vehicle using the lock switch in the vehicle but not off the factory remote. If I wire the input activation to the vipers lockout put and I arm the system twice from the viper remote it starts but not from the factory remote. Alittle guidance would be greatly appreciated.
Replies:
Posted By: pts760
Date Posted: June 30, 2014 at 9:12 PM
Use the factory door lock motor wire and a SPDT relay. From my research, on readyremote.com, I found the factory door lock motor wire is Red, 5-Wire, dash fuse box, white 19 pin plug, pin 6.
Connect the relay as follows:
85 & 87: Ground
86: Red, factory door lock motor wire
87a: N/A
30: H2/21 WHITE/ Blue, remote start activation input
Program your activation pulses as you desire. This will activate the remote start from the factory remote or the door lock switch the programmed amount of pulses that are programmed.
-------------
I drink current, eat ohms, and bleed voltage
|