compustar cm7200 reservation mode

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137266
Printed Date: April 19, 2024 at 1:33 AM

Topic: compustar cm7200 reservation mode

Posted By: tianot
Subject: compustar cm7200 reservation mode
Date Posted: September 16, 2014 at 12:58 AM

hello guys! i need your help.

i installed a compustar cm7200 module into a 2002 mazda protege manual transmission. i did all the wirings from clutch to parking brake up to door trigger. when i set the car into reservation mode the car will not lock the door once you get out and close the door. when i set the reservation mode the car still running when i take off the key and then open the door and close it. the car shut off once the door is close, but it won't lock and it will not activate the reservation mode. when i try to remote start the start im getting a error 7 which is reservation is off. do u guys have any idea whats wrong with it? do i need something to do with the door trigger? i use the BLACK/ blue door trigger wire from the harness to rear.

thanks

-------------
tianot

Replies:

Posted By: dman007
Date Posted: September 16, 2014 at 8:15 PM

The fact that the car shuts down, once the door is closed. Proves that the door trigger is correct, I would look into the lock/unlock wires.
Do they function normally without attempting reservation mode?

-------------
DTS Performance
St Petersburg, FL

Posted By: tianot
Date Posted: September 16, 2014 at 8:59 PM

the lock and unlock are working good when the car is not in reservation mode. i use the light GREEN/ red wire. lock to 1.5k and unlock to ground.
i tried to use a another cm7200 module and it does the same thing. you think its something wrong with the transmitter?
how about the domelight delay settings? do i need to adjust that to auto?

-------------
tianot

Posted By: supermike05
Date Posted: September 16, 2014 at 11:27 PM

have you made sure that the green loop is cut so that the cm7200 brian knows that the car is a manule transmision

Posted By: supermike05
Date Posted: September 16, 2014 at 11:28 PM

have you made sure that the green loop is cut so that the cm7200 brian knows that the car is a manule transmision

Posted By: tianot
Date Posted: September 16, 2014 at 11:31 PM

the car is a manual transmission.
green loop cut is for automatic transmission.

-------------
tianot