flcan reset, do i need to reflash firmwar
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137346
Printed Date: May 13, 2025 at 6:56 PM
Topic: flcan reset, do i need to reflash firmwar
Posted By: soonerfan51
Subject: flcan reset, do i need to reflash firmwar
Date Posted: September 28, 2014 at 3:33 PM
I reset my flcan on accident during install. Do I need to have the firmware reflashed, or should it still be good to go?
Thanks.
Replies:
Posted By: kreg357
Date Posted: September 28, 2014 at 3:46 PM
Still good to go. After it is flashed with the correct application firmware, you can do a Factory reset with no problem. I always do a Factory Reset and then set the Installation Mode just prior to vehicle programming. The Factory Reset will loose the vehicle specific programming if you had already done that final step.
-------------
Soldering is fun!
Posted By: soonerfan51
Date Posted: September 28, 2014 at 4:13 PM
Okay. Good.. now I get a crank with no start. Also the doors don't lock when I hit the lock on the remote fob.
One thing I am not sure about is the pink wire out of the flcan. I have it hooked up to the pink ignition1 wire on the vehicle harness along with the pink ignition1 from the ca6553. Is this correct?
Appreciate all your help.
Posted By: soonerfan51
Date Posted: September 28, 2014 at 6:37 PM
Got it all figured out. The folks I purchased the flcan module from flashed it with ads firmware instead of dbi. All is good so far..
|