chevy cruze parking lights

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137620
Printed Date: May 02, 2024 at 4:29 PM

Topic: chevy cruze parking lights

Posted By: shafferny
Subject: chevy cruze parking lights
Date Posted: November 08, 2014 at 10:29 AM

Quick question. Testing the negative parking light trigger on a 2012 Chevy Cruze. It appears to rest at about 10-12v and go to ground when the lights are activated. Is this the correct wire to trigger with the negative RS output. It's the GREEN/ grey wire, pin 22 of the white BCM connector.

FWIW, I'm installing a CM7200s with a Blade-AL.

Thanks!

-------------

Replies:

Posted By: dasbogie
Date Posted: November 08, 2014 at 10:56 AM

sounds like you're on the right wire, when you say goes to ground, you mean meter reads 0.00 volts correct? you could also put your positive meter lead to one of the RED / striped wires at the bcm and your negative lead to suspect wire then voltage should read opposite, zero parking lights off and 12volts lights on

-------------
Advanced

Posted By: shafferny
Date Posted: November 08, 2014 at 11:02 AM

dasbogie wrote:

sounds like you're on the right wire, when you say goes to ground, you mean meter reads 0.00 volts correct? you could also put your positive meter lead to one of the RED / striped wires at the bcm and your negative lead to suspect wire then voltage should read opposite, zero parking lights off and 12volts lights on

Correct. Positive lead off my DMM is connected to power and the negative lead is connected to the suspect wire. At rest it's testing 10-12v(parking lights off) and with the parking light on it shows 0 voltage.

Thanks for the reply!

-------------