Autopage c3-rs730 wiring info
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137630
Printed Date: May 04, 2024 at 5:18 AM
Topic: Autopage c3-rs730 wiring info
Posted By: dblee50
Subject: Autopage c3-rs730 wiring info
Date Posted: November 09, 2014 at 10:08 AM
I am about to attempt install of an Autopage RS-730 remote/alarm system in my 2006 Honda Civic Hybrid. I also have a Xpresskit PKALL that I intend to use for the bypass versus the key method used in the alarm installation instructions. I have figured out most of what connections need to be made but would like clarification on a few as follows:
1.H6/pin 1. ground output while running. Best I can tell is where the PKALL blue/white wire will connect. PKALL says while running status.
2. H6/pin 3. 2-step unlock/factory disarm... Looks like this should go to brown wire for factory alarm disarm. I think this cause there is a separate harness with the alarm that goes to door lock/unlock.
3. H6/pin 8. Not sure where to find wire to tap into neutral safety line.
4. H6/pin 11. accy 2 output. Not sure I need to connect this to anything.
5. H6/pin 13. ign 3 output. Installation sheet shows transponder bypass setup using a key and coils. If PKALL works, I don't think anything will connect here.
6. H6/pins 16 and 19. I assume both of these would connect to the pin switch I will install in the hood to actuate when hood is open.
7. H1 the large wire harness. I'm getting confused between data sheets on the car and the Honda service manual. Bulldog shows ign 2 as N/A, but manual shows it does have an orange ign 2. It also shows red for the ACC. Bulldog shows orange as the ACC1 and shows red for ACC2. The instruction sheet for alarm isn't clear enough that I understand what goes where. I understand the first three wires, its the pink and brown that I'm uncertain on.
Any help appreciated. I want to make sure before I start where everything is supposed to go. Thanks.
Replies:
Posted By: dblee50
Date Posted: November 12, 2014 at 4:05 PM
OK. I installed remote. Lights work, alarm horn works, it's programmed according to PKALL and remote instructions, but nothing happens when trying to remote start. Remote says engine stop. I've tried reprogramming but it still does the same. doors lock and unlock as they should.
Posted By: max626
Date Posted: November 12, 2014 at 4:41 PM
I also have the same alarm with the same issue, i wish someone would chine in and save us both lol
Posted By: dblee50
Date Posted: November 13, 2014 at 6:47 PM
OK, programming was issue best I can tell. I reprogrammed remote to timed start and it worked. Since then, I've added tach wire and reset remote for that and all seems to be working well.
Posted By: lucasoil4u
Date Posted: November 18, 2014 at 1:32 PM
Did you hook up the neutral safety wire (BLACK/ white) to ground?
|