2006 dodge ram remote start w/ heat seats

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137633
Printed Date: May 06, 2024 at 4:46 AM

Topic: 2006 dodge ram remote start w/ heat seats

Posted By: dksob81
Subject: 2006 dodge ram remote start w/ heat seats
Date Posted: November 09, 2014 at 3:15 PM

I have a 2006 Dodge Ram 1500 Laramie. I installed my Viper 5904 remote starter with a DBALL2. They are connected using D2D. The DBALL2 has a Heated Seat feature, which I have activated and set to "ALWAYS ON". The issue is it doesn't work. Which is understandable bc I don't know how it would turn them on.

I connected everything according to the Wiring Diagram for the DBALL2 for my truck, TYPE 4 installation.

Any ideas on what I have to connect to get them to work?

Replies:

Posted By: kreg357
Date Posted: November 09, 2014 at 4:03 PM

It would appear that the DB-ALL2 flashed with the 402 Chrysler V5.06.01 firmware is not capable of turning on the
heated seats in your Dodge RAM 1500. Check out the Features Supported Table on Page 2 of the install guide :
https://www.xpresskit.com/images/vc/btnInstallGuide_on.gif It is not listed, only the 300, Charger & Magnum are
supported. It might be possible to hard-wire them but I don't have any specific info.

-------------
Soldering is fun!

Posted By: dksob81
Date Posted: November 09, 2014 at 4:39 PM

You're right, didn't notice that...

Anyone have any info on wiring it?

Posted By: yellow_cake
Date Posted: November 11, 2014 at 1:45 AM

I'll try to look it in the factory wiring diagram.

Posted By: yellow_cake
Date Posted: November 11, 2014 at 4:24 PM

Just tried, I no longer have access to dealer connect. posted_image

Posted By: dksob81
Date Posted: January 10, 2015 at 8:40 AM

anyone else have any info?

Print Page | Close Window