Print Page | Close Window

d2d between prostart and dball2

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137729
Printed Date: May 14, 2025 at 4:40 PM


Topic: d2d between prostart and dball2

Posted By: xcessiv46
Subject: d2d between prostart and dball2
Date Posted: November 18, 2014 at 8:50 AM

Dear fellow DIYers,

I never got D2D to work between my Prostart remote starter (acquired at Canadian Tire) and my DBALL2. I had to hook the wires directly.

Is this normal?

Thanks



Replies:

Posted By: sparkie
Date Posted: November 18, 2014 at 3:10 PM
Yes. The Prostate units don't support D2D.

-------------
sparky



Posted By: xcessiv46
Date Posted: November 19, 2014 at 9:42 AM
sparkie wrote:
Yes. The Prostate units don't support D2D.

Despite this being mentionned in the installation manual? :(

"Remote starters of this series have the ability to work in two way mode (D2D) with Xpresskit bypass modules"



Posted By: sparkie
Date Posted: November 19, 2014 at 12:44 PM
I have done quite a few Prostarts and have never gotten D@D to work. I always hardwire the bypass module. I haven't done one for a couple of years so they may have changed. Check to see if the bypass type is programmable in the programming menus. The Autostart versions of those modules are programmable for bypass type.

-------------
sparky



Posted By: xcessiv46
Date Posted: November 20, 2014 at 8:10 AM
Ok thanks, will check!


Print Page | Close Window