2014 toyota rav4 remote start idatalink

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137750
Printed Date: May 10, 2025 at 2:52 PM

Topic: 2014 toyota rav4 remote start idatalink

Posted By: andrey4964
Subject: 2014 toyota rav4 remote start idatalink
Date Posted: November 20, 2014 at 8:36 PM

Hello. I need help. I am about to start installation on 2014 Toyota RAV4 Push Start button type. I will be installing Prestige Aps901E with Idatalink Ads-DLSL CA2. I have a problem with Idatalink diagram. On diagram its calling to connect Idatalink pink wire ignition(input)+ to black connector at steering lock and to ignition(input) on remote start with diode??? Usually on remote start its ignition+ is output. Unless it's a typo on diagram. What should I do.
Thank you.

Replies:

Posted By: Mark Mizenko
Date Posted: November 20, 2014 at 10:48 PM

You are reading the diagram correctly. The pink is an INPUT in this case, the diode is added to the pink from the remote start to prevent it from sending power out. The diode will allow the RS to still sense when ignition is on, along with the ADS module.

Just follow the diagram exactly, you'll be fine.

Posted By: andrey4964
Date Posted: November 22, 2014 at 2:14 PM

Thank you

Print Page | Close Window