2014 nissan rogue p.lights
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137873
Printed Date: May 05, 2024 at 8:41 AM
Topic: 2014 nissan rogue p.lights
Posted By: pts760
Subject: 2014 nissan rogue p.lights
Date Posted: December 04, 2014 at 8:23 PM
I'm doing a 2014 PTS Rogue. I have everything hooked up via idatalink but the parking lights are a B!@#%. Anyone have any luck with them or does anyone have a diagram besides ready remote or bulldog security.
-------------
I drink current, eat ohms, and bleed voltage
Replies:
Posted By: tedmond
Date Posted: December 04, 2014 at 9:13 PM
i did this rouge a while back (aunt has one) and the parking lights were white (-) at the bcm white or grey plug, cant remember exactly. it turns on the led parking lights and low beams.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: sparkie
Date Posted: December 04, 2014 at 9:29 PM
Parking lights are positive and there are isolated circuits for front and right rear and left rear. The ones for the rear are in harness in drivers kick panel. The front one is underwood. I believe the wires in kick are RED / violet and BROWN / white. I don't bother with front ones as headlights come on when started. Use relays to isolate circuits.
-------------
sparky
Posted By: pts760
Date Posted: December 04, 2014 at 10:16 PM
Can't I just isolate the circuits with (2) 3 or 5 amp diodes
-------------
I drink current, eat ohms, and bleed voltage
Posted By: kreg357
Date Posted: December 05, 2014 at 12:18 AM
As per Ted's post, using a White (-) Parking Light wire on a Gray BCM plug.
You might be able to do the parking lights from inside the vehicle with a (-) Parking Light signal and a relay to open another
wire. Both wires are found on connector M18 of the BCM. See Page 3 of this DB-ALL install guide for the wiring details :
https://www.xpresskit.com/DocumentDownload.aspx?documentid=9516&productid=553&firmwareid=9469 ------------- Soldering is fun!
Posted By: tedmond
Date Posted: December 05, 2014 at 11:07 AM
when i used the fortin evo-all standalone + FTD100 RF decoder + 901ss, i didn't have to interrupt the yellow hazard wire.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: pts760
Date Posted: December 05, 2014 at 7:47 PM
I ended up using the yellow wire at the BCM suggested by Kreg357. I interrupted it with a relay and it worked flawlessly. The headlights on along with the parking lights. I didnt prefer the headlights activating but the time involved with wiring the positive parking light circuit wasn't worth my time. Thanks for the help
-------------
I drink current, eat ohms, and bleed voltage
|