remote start on ford probe wont start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137874
Printed Date: April 28, 2024 at 1:10 PM
Topic: remote start on ford probe wont start
Posted By: gsu2323
Subject: remote start on ford probe wont start
Date Posted: December 04, 2014 at 11:48 PM
Hi, I have a ford probe 89 and i ve been trinng to install a pro star 4 botons remote start on it.
All the wiring is done, ignition, starter, cluch switch, brake, handbrake, 12V constant, -ground, locks and tach, i dont think im forgetting anything.
I programed the control and try to enter on ready mode, but it wont enter on ready, it flashes 1 time insteead of 2.
Someone knows what could be the answeer here.
I got another brain unit and try it and is tha same, so is not broken or anything.
Thanks guy
Replies:
Posted By: shark mobile
Date Posted: December 11, 2014 at 9:03 PM
Well with it being an '89 it has no transponder so the first thing I suggest is that you meter all of your connections and ensure each is receiving the correct voltag...make sure all fuses are good and the yellow loop is not cut on the back of the pro start.
Now I'm hoping you didn't miss accessory and the driver door pin which was omitted from the above message...without the door pin being tagged the system will not go into ready mode...hope that helps.
-------------
Solder, tape, repeat!
Posted By: gsu2323
Date Posted: December 12, 2014 at 2:45 PM
My door pins dont work, i ve been trying to get them but its really hard. can a ground them? would that work?
Posted By: howie ll
Date Posted: December 12, 2014 at 3:55 PM
Yes.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: gsu2323
Date Posted: December 12, 2014 at 6:54 PM
Okay, today i make a trip to a car wreker and got a couple of door pins, so i conected them when i got home, also conected the door POS, to the dome light, 12v in.
Nothing, still the same, when i finish my ready mode lights flashes only once, in the manual says should flash twice.
And ofcourse wont start...
Posted By: yellow_cake
Date Posted: December 12, 2014 at 7:30 PM
Hi, can you post a list of the wires and where you've connected them to?
|