99 jeep grand cherokee and xk09

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137877
Printed Date: May 06, 2025 at 12:55 PM

Topic: 99 jeep grand cherokee and xk09

Posted By: lostissues
Subject: 99 jeep grand cherokee and xk09
Date Posted: December 05, 2014 at 1:21 PM

I am going to be doing a remote start in a 99 Jeep Grand Cherokee, I am pretty sure that I need the XK09, will this come pre-loaded with the correct firmware for the 99 GC?

Thanks,
Jonathan

Replies:

Posted By: kreg357
Date Posted: December 05, 2014 at 2:11 PM

Maybe and maybe not. You need 9.JDL v2.06. There should be a white sticker on the bottom of module that shows the firmware loaded at the factory.

If you don't have the XKLoader2 cable, make sure the seller flashes the correct firmware prior to shipment.

There is a Pictorial on this vehicle : https://www.the12volt.com/installbay/forum_posts.asp?tid=137527 Used a different bypass module but a lot of the wiring is the same.

-------------
Soldering is fun!

Posted By: lostissues
Date Posted: December 05, 2014 at 3:52 PM

are there any other bypasses that do not need to be programmed? I know that we used to use the DLPKGMs but it looks like they are not available now.

Posted By: kreg357
Date Posted: December 05, 2014 at 4:10 PM

The Fortin INT-SL+ is a good choice that comes pre-flashed. There are "on-line" sellers that will flash the module for you prior to shipment. You could even get an iDatalink bypass module, flashed with the DL CH6 firmware, like the one used in the Pictorial. I see several EBay sellers with EVO-ALL's and ADS AL-CA's listed with "firmware loaded" options. ( I don't use XPressKit modules so I didn't check for them.)

-------------
Soldering is fun!

Print Page | Close Window