remote start 2010 honda crv
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137945
Printed Date: May 13, 2025 at 12:36 PM
Topic: remote start 2010 honda crv
Posted By: timothy_nd28
Subject: remote start 2010 honda crv
Date Posted: December 11, 2014 at 6:42 PM
Hello all, what a awesome forum this is!
Okay, installing a remote start on a 2010 Honda CRV and using a Dball2 and Avital 4103LX all in D2D. From the preliminary research, it looks like a very easy install (easier than my last job 05 Grand Caravan).
On the dball2 type 2 instructions, I get this odd note saying this about the lock/unlock outputs:
So here's my question, is it as simple as what they say? I was under the impression that the output on the dball 12 pin connector only had a 500ma output, which isn't much. Do I go on blind faith and connect the wires as they say, or do I install isolation relays?
Thanks in advance for any advice
Okay, installing a remote start on a 2010 Honda CRV and using a Dball2 and Avital 4103LX all in D2D. From the preliminary research, it looks like a very easy install (easier than my last job 05 Grand Caravan).
On the dball2 type 2 instructions, I get this odd note saying this about the lock/unlock outputs:
So here's my question, is it as simple as what they say? I was under the impression that the output on the dball 12 pin connector only had a 500ma output, which isn't much. Do I go on blind faith and connect the wires as they say, or do I install isolation relays?
Thanks in advance for any advice
Replies:
Posted By: sparkie
Date Posted: December 11, 2014 at 6:56 PM
Posted By: tedmond
Date Posted: December 11, 2014 at 9:19 PM