remote start, 2012 kia sorento
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138236
Printed Date: May 05, 2024 at 3:46 AM
Topic: remote start, 2012 kia sorento
Posted By: doug1025
Subject: remote start, 2012 kia sorento
Date Posted: January 12, 2015 at 9:51 PM
hey guys I installed a remote start on a 2012 kia sorento with a pushbutton start,v6,auto trans.i used a prestige aps-57e and an flcan.it locks and unlocks the doors but will not crank.i do notice that when the doors are locked with the remote key fob the led on the antenna keeps blinking and the led on the flcan does not light up while trying to remote start. this is my 4th remote install and I am learning,any ideas?
-------------
doug1025
Replies:
Posted By: chev104275
Date Posted: January 13, 2015 at 7:56 AM
I do mainly idatalink stuff but flash link is the same thing. What did you flash the module with ? Did you follow the install guide correctly ? Are you using the 3 diodes the guide calls for ?
-------------
If i Can't Install it I Don't need it Joe
Posted By: tedmond
Date Posted: January 13, 2015 at 8:54 AM
keep the door shut and locked then try to remote start. it will not crank with a door open. verify the 2 pts wires and ensure brake lights go on during start.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: doug1025
Date Posted: January 13, 2015 at 10:01 PM
hey chev thanks for reply,i flashed the module from flashlogic site,i have done this before,i did install the diodes where they are suppose to go,i followed the wiring diagram and wired it exactly as shown,i will get vehicle back and recheck everything again.maybe I am overlooking something.
-------------
doug1025
Posted By: doug1025
Date Posted: January 13, 2015 at 10:06 PM
hey ted I did lock the doors but did not check brake lights during starting attempt,can you explain this to me about the brake lights,thanks
-------------
doug1025
Posted By: tedmond
Date Posted: January 13, 2015 at 10:34 PM
to start the vehicle, you need to step on the brake and hold the start button. to trick this vehicle into starting, the bypass turns on a relay to energize the brake circuit temporarily. when remote starting make sure brake lights turn on for a few seconds. it will disengage right after starting.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: shark mobile
Date Posted: January 14, 2015 at 7:57 PM
Never used a prestige but I know with several other brand you have to program the RS for push-to-start...worth checking I think
-------------
Solder, tape, repeat!
|