installing keyless entry
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13833
Printed Date: September 08, 2025 at 6:40 AM
Topic: installing keyless entry
Posted By: dazed
Subject: installing keyless entry
Date Posted: May 22, 2003 at 6:59 AM
Here's the deal...my alarm has lock/unlock capabilities,but was not hooked up during original install. Anyway, Ineed to know what I need and how to's. My car has power locks (when I push the tab to lock the drivers door it also locks the pass. side, but I have to hold up on the handle for the pass. to lock). Thanks in advance.
Replies:
Posted By: draasch
Date Posted: May 22, 2003 at 8:25 AM
what is the yr make and model of car????? ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: jrcaraudiofreak
Date Posted: May 22, 2003 at 9:36 AM
David, Could you tell me the wiring for a 97 Grand Am so I can do my keyless entry? Is it 3, 4, 5 positive or negative and would you be able to tell me which wire is which and color, etc. Thanks alot! please e-mail it too jrmcgrath2001@hotmail.com
Posted By: dazed
Date Posted: May 22, 2003 at 3:20 PM
My car is a '93 MX6. The alarm is an older Chapman module.
Posted By: dazed
Date Posted: May 22, 2003 at 3:21 PM
That's a mazda if you didnt know....
Posted By: draasch
Date Posted: May 22, 2003 at 3:24 PM
Power Lock ADD ACTUATOR ACTUATOR NEEDED IN DRIVER DOOR #204
Power Unlock ADD ACTUATOR ACTUATOR NEEDED IN DRIVER DOOR #204
#204- See Adding Actuator Door Lock Diagram. ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: dazed
Date Posted: May 22, 2003 at 3:27 PM
so I just need to do drivers door? do I need any relays?
Posted By: dazed
Date Posted: May 22, 2003 at 3:28 PM
so I just need to do drivers door?
Posted By: draasch
Date Posted: May 22, 2003 at 3:30 PM
yes im not sure what your outputs are coming from the alarm.
if you add a motor and you operate the drivers door, it will control the rest of them. you can use a DLS from omega with two relays. it makes it soooo much easier ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
Posted By: dazed
Date Posted: May 23, 2003 at 7:03 AM
two outputs from the alarm say lock and unlock, but not wiring going to them. i assume that is where i need to
wire up. what is a DLS? door lock system? Thanks for the help.
Posted By: draasch
Date Posted: May 23, 2003 at 8:28 PM
yes that is a Door Lock Socket...look at this pic........
https://www.wiringinstructions.com/204.htm ------------- Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
|