avital 4103 not programming
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138355
Printed Date: May 11, 2025 at 7:26 AM
Topic: avital 4103 not programming
Posted By: neceltic
Subject: avital 4103 not programming
Date Posted: January 27, 2015 at 7:37 PM
Installing Avital 4103 and DBALL2 on 2004 Chevy Express 3500. There are a couple of problems - FOBs will not program and D2D will not program.
I connected per instructions. Had the DBALL2 flashed. I can connect the Activation Input to ground and the DBALL2 activates and the 4103 relays click. The accessories comes on, but it won't crank. If I put the key into run and connect the Activation Input to ground, the van will start.
I tried to program the 4103 for D2D. When I disconnect power, ground the Activation Input (WHITE/ Blue), and connect power, I get no LED light. However, when the unit is connected, I can use the valet button and get LED indication. Which leads to the other problem. Even though I get LED indication for FOB programming, the FOBs will not operate. I used the sequence for clearing the remotes and tried reprogramming but it did not work either. I also tried resetting to all factory defaults but still no lights when trying to get to D2D mode.
Any ideas what is going on? Is the 4103 bad?
-------------
neceltic
Replies:
Posted By: Mark Mizenko
Date Posted: January 27, 2015 at 9:10 PM
Is the antenna plugged in.
|