Viper 5906v activation input

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138576
Printed Date: May 09, 2025 at 11:29 AM

Topic: Viper 5906v activation input

Posted By: steely605
Subject: Viper 5906v activation input
Date Posted: March 01, 2015 at 6:26 AM

Is the Viper 5906v activation input the same as a instant trigger input? I am putting in stilt sensor and I need an instant trigger input.

Replies:

Posted By: kreg357
Date Posted: March 01, 2015 at 6:38 AM

No. The Activation Input is used to initiate a remote start. Here is the wire description from the 5901 Install Guide :

This input comes from the factory set to 1 activation pulse. This means that it is necessary to have a single ground pulse on the WHITE/ blue wire for the remote start to activate or to deactivate.

-------------
Soldering is fun!

Posted By: howie ll
Date Posted: March 01, 2015 at 9:30 AM

Tilt sensor is wired thus:-
Blue to H2 blue trunk sensor, diode separate.
Orange to orange on H1
Red to red on H1

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: steely605
Date Posted: March 01, 2015 at 9:41 AM

Thanks for your reply.

Print Page | Close Window