Opel astra 1996 immobiliser bypass
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138635
Printed Date: April 19, 2024 at 12:01 AM
Topic: Opel astra 1996 immobiliser bypass
Posted By: chassis
Subject: Opel astra 1996 immobiliser bypass
Date Posted: March 10, 2015 at 12:40 PM
Hi guys I want to bypass an immobiliser module from this vehicle.it works like this.switch ignition on,engine/immobiliser light comes on,crank,car will start and immobiliser light will go away.this box is black and is located behind the driver kick panel surounded by a black strap with a relay next to it.it has 2 white plucks plucked it to it,1 big and 1 small.is there any wires that needs to be bridge somehow.if I pluck this black box out while car idle ,car then stall.
-------------
Do it once,do it right - This means no short cuts. You never get paid twice for having to do the job twice because it wasn't done right the first time.
Replies:
Posted By: howie ll
Date Posted: March 10, 2015 at 1:49 PM
You can't by-pass this unless you use a key-in the box method such as DEI 556U as used for remote starts.
There's another method though, PM me.
Do not attempt to cut or loop any wires, it won't work. The immobiliser sends a coded/encrypted data message to the engine management + starter.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: penca
Date Posted: September 05, 2015 at 2:51 AM
howie ll wrote:
.... There's another method though, PM me.
... .
GOOD MORNING,
I have the same problem ... , can you say to me in PM ,how can I do?
thank you
Carlo
Posted By: howie ll
Date Posted: September 05, 2015 at 2:58 AM
Factory or aftermarket? What's the procedure to start the car?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: penca
Date Posted: September 05, 2015 at 3:18 AM
Hello,
my car is Opel CORSA 1996, I would like to start the engine without chip pcf7931, could you tell me how I can do, without using programmers OBD?
Posted By: howie ll
Date Posted: September 05, 2015 at 3:23 AM
You can't if it's factory, aftermarket just trace the wiring disconnect and make good. Open up a key, remove the graphite shape which is the chip, remove steering place it on the plastic antenna ring around the ignition switch. Wait a minute or so see if the key without the chip starts the car but first you have to determine whether it's factory or aftermarket. There won't be a chip in the key if it's aftermarket but there might be a red LED or a receptacle.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: penca
Date Posted: September 05, 2015 at 3:52 AM
I was hoping with the bypass, as you see here :
https://www.youtube.com/watch?v=1sYhHxudt-8
Posted By: howie ll
Date Posted: September 05, 2015 at 3:54 AM
You haven't answered my question, factory or aftermarket.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: penca
Date Posted: September 05, 2015 at 4:20 AM
the car came out of the factory ,with the original Opel immobilizer
Posted By: howie ll
Date Posted: September 05, 2015 at 4:33 AM
Then I've already given you the answer and forget the U tube video.
A good auto locksmith might have the software to disable it through the OBD.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: penca
Date Posted: September 05, 2015 at 5:20 AM
o.k.
thanks for your quick answers
Carlo
Posted By: penca
Date Posted: September 05, 2015 at 5:39 AM
Posted By: howie ll
Date Posted: September 05, 2015 at 5:41 AM
Stop driving yourself mad, look closely the authorities have pulled it.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|