Viper 5706v Valet Mode

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139217
Printed Date: May 15, 2025 at 8:54 AM

Topic: Viper 5706v Valet Mode

Posted By: mtsu_bravo
Subject: Viper 5706v Valet Mode
Date Posted: July 23, 2015 at 12:05 AM

I think I may have some how deleted the remote pairing and locked the viper in valet mode. The LED on the dash stays solid which indicates valet mode best I can tell. The remotes I accidentally removed when trying to reset the system. Any way to do a hard factory reset or get it out of valet mode without the remotes????

Replies:

Posted By: howie ll
Date Posted: July 23, 2015 at 2:33 AM

Use the following steps to manually enter and exit Valet Mode:
1. Turn the ignition switch On and then Off
2. Immediately press and release the control button once
3. The control center LED turns On when entering and Off when
exiting.
Couldn't YOU have turned to page 41 in the owner's manual?

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: mtsu_bravo
Date Posted: July 23, 2015 at 12:30 PM

That doesn't work, that is why I was asking for a hard reset. The light is solid the entire time. I cant get it to go off even with the ignition started.

Posted By: howie ll
Date Posted: July 23, 2015 at 12:32 PM

Try grounding the green at H2 connector on the Viper.
One other possibility is a poor ground, test the voltage between your grounding point and any of the input fuses.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: kc9udx
Date Posted: December 28, 2017 at 3:04 PM

mtsu_bravo wrote:

That doesn't work, that is why I was asking for a hard reset. The light is solid the entire time. I cant get it to go off even with the ignition started.

Did you ever figure this out?

I have the same issue. The light is always on solid, no matter what I do. The control button does not seem to do anything at all. (Is there a safe way to test this button?)

I can lock/unlock, but cannot remote start because there's an error in the configuration for MTS (7 flashes code). I have an automatic transmission but cannot select this option because the control button does not seem to work.