found pre installed remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139556
Printed Date: July 04, 2025 at 12:31 AM
Topic: found pre installed remote start
Posted By: stlguy99
Subject: found pre installed remote start
Date Posted: October 11, 2015 at 7:10 PM
Hello,
I purchased a Fortin evo-all. Evo-chrt5 for my 2005 jeep grand cherokee. When I started ripping the dash apart I found a remote start had been installed before I bought the vehicle.
I would replace the remote start with the identical box to makes things easy, but I want to get two way communication and a decent range.
The installed bypass is the idatalink ads-al.
The remote start installed is auto page rs-603. No remotes
Is there a unit made by autopage that I could upgrade to with minimal change in connections?
Thanks,
Dustin
Replies:
Posted By: stlguy99
Date Posted: October 11, 2015 at 7:39 PM
Oh and ....not planning on using the fortin now.
Posted By: stlguy99
Date Posted: October 12, 2015 at 1:30 AM
Hello, I have looked into upgrading to the RS 625. Can anyone help me with the connections I was not able to match up with the 603 below? They are indicated with a "+" next to each one.
RS 625 H1, H2, and H6 connectors match identically with RS 603.
Below connection equivalents between RS625 H7 and RS603 H3
+H7 PIN1 ORANGE - H3 UNKNOWN? = Grounded Output When Armed
H7 PIN2 BLUE - H3 PIN2 WHITE/ BLUE = Instant Start and Turn Off Input
H7 PIN3 WHITE/ VIOLET - H3 PIN5 WHITE/ VIOLET = Brake Switch Shutdown Input
H7 PIN4 BLACK/ WHITE - H3 PIN4 BLACK/ WHITE = Neutral Safety Switch
H7 PIN5 YELLOW - H3 PIN10 YELLOW = Ignition 3 Control Output
H7 PIN6 BLUE/BLACK - H3 PIN9 BLUE/BLACK = Accessoy 2
H7 PIN7 BROWN / BLACK - H3 PIN7 WHITE = Ground When Running Output
H7 PIN8 XX
H7 PIN9 WHITE/ RED - H3 PIN1 WHITE/ RED = Tachometer Signal Input
H7 PIN10 WHITE/ BLACK - H3 PIN3 WHITE/ BLACK = Negative Hood Pin Safety Shutdown
+H7 PIN11 PINK - H3 UNKNOWN? = Step Unlck/Fctry Disrm/Snsr Bypss
+H7 PIN12 WHITE - H3 UNKNOWN? = Dome Light Control Output
H7 PIN13 GRAY - H3 PIN6 GRAY = Trunk Release
+H7 PIN14 GRAY/BLACK - H3 UNKNOWN? = Starter 2 Output
H3 PIN8 UNUSED - INDICATES"Programmable Output"
Thank You
|