How to wire Starter Kill with 2 starter wires?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139583
Printed Date: May 21, 2024 at 6:32 PM
Topic: How to wire Starter Kill with 2 starter wires?
Posted By: mduong25
Subject: How to wire Starter Kill with 2 starter wires?
Date Posted: October 16, 2015 at 1:20 PM
If your vehicle has 2 starter wires, how would you wire a starter kill setup using a relay? And How do you determine if you will use a normally open or normally closed wiring setup? Is it vehicle dependent? And are diodes necessary?
Replies:
Posted By: howie ll
Date Posted: October 16, 2015 at 4:19 PM
You'll only need it on the wire designated as starter 1.
Standard type.
5 pin relay mandatory wiring and pin positions.
GWA (ground when armed) to 85.
Ign (live when cranking) to 86
Ign. sw. side to 87a
Starter side to 30
87 not used.
1N4004 diode across 86 and 85, band to 86.
That's a normally closed type, IMO of 40+ years experience s the only type to use, it's fail safe.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: October 16, 2015 at 4:22 PM
I don't even know why you're posting, can't you see where this was already answered in another of your posts?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|