Print Page | Close Window

2004 F350 Viper 4706v remote start

Printed From:
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
Printed Date: November 30, 2022 at 5:52 AM

Topic: 2004 F350 Viper 4706v remote start

Posted By: ricerocketc
Subject: 2004 F350 Viper 4706v remote start
Date Posted: October 25, 2015 at 2:31 PM

Looking to install a viper remote start in my 04 F350 diesel. It has a factory keyless entry with alarm and no chip key. After opening the dash I noticed that the "factory" alarm is actually a code system alarm model H63DB which also has the ability to be used as a remote start as well. Because the viper is 2way I'd like to still install it, my question is will I have to remove the code system alarm/starter or can I wire the viper to arm/disarm the code security system.

viper wiring guide

h63db main harness

h63db extended harness


Posted By: Velocity Motors
Date Posted: October 25, 2015 at 9:05 PM
Use the DISARM input (+) BROWN wire to the status putput wire from the Viper and this will disable the alarm system for the Code Alarm.

Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: howie ll
Date Posted: October 26, 2015 at 1:18 AM
Jeff you wrote disarm input (+) and connect to status output wire from Viper. But that goes to ground (-).
Regards, Howard.

Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: ricerocketc
Date Posted: October 26, 2015 at 8:54 PM
So am I to understand this solution won't work then?

Posted By: ricerocketc
Date Posted: October 29, 2015 at 6:57 PM
Anyone? I'd like to get this project going this weekend

Print Page | Close Window