DBALL2 and autolight issue

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139623
Printed Date: May 10, 2025 at 6:48 AM

Topic: DBALL2 and autolight issue

Posted By: mduong25
Subject: DBALL2 and autolight issue
Date Posted: October 26, 2015 at 12:07 PM

Installed a Viper RS with a DBALL2, followed diagram to interrupt the autolight but autolight still stays on after remote start shutdown. Does anyone have any suggestions or am I missing something? posted_image

Replies:

Posted By: mduong25
Date Posted: October 26, 2015 at 12:09 PM

mduong25 wrote:

Installed a Viper RS with a DBALL2, followed diagram to interrupt the autolight but autolight still stays on after remote start shutdown. Does anyone have any suggestions or am I missing something?

This was done on a 2007 Lexus GX470, autolight wire is green orange at headlight switch.

Posted By: beegbie
Date Posted: October 26, 2015 at 8:57 PM

Do you know what firmware version is on the db=all? Looks like there was a issue that was fixed a while ago.

"v2.41- Fixed autolamp and DRL issue on key type car"

Posted By: mduong25
Date Posted: October 27, 2015 at 1:24 PM

I have the latest version loaded in (v3.19). I am assuming that this version should cover v2.41's fixes as well? Please advise. Thank you.

Posted By: beegbie
Date Posted: October 27, 2015 at 8:35 PM

Yes it should. Do you have a dmm? The orang/red yellow/red should have continuity whenever the remote start is off but not when it's active.

Posted By: smokeman1
Date Posted: October 28, 2015 at 6:19 AM

Are all of the doors closed after shut down?
Possibly, are the ORANGE / red and yellow/red on the wrong side of the autolight wire?

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Print Page | Close Window