parking lights, 06 Jeep Liberty
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139700
Printed Date: May 24, 2025 at 10:24 AM
Topic: parking lights, 06 Jeep Liberty
Posted By: belvedere
Subject: parking lights, 06 Jeep Liberty
Date Posted: November 09, 2015 at 10:19 PM
I'm hoping some of you experts will help out an amateur. I'm installing an Avital 4113 in our '06 Jeep Liberty. Though I'm a DIYer, I do most of my own auto repair, and I'm a CBET, so I have a good understanding of electronics.
I need advice on the parking light hookup. The wiring guide that the seller sent to me says that the parking lights need a (-) polarity signal through a 910-ohm resistor, and it says "MUST use relay". I'm a little confused, because the vehicle already has a relay for the parking lights in the factory circuit. Can someone tell me exactly how to wire this? Thanks!
Replies:
Posted By: chev104275
Date Posted: November 10, 2015 at 4:50 AM
Liberty Parking Lights
You can also find the parking light relay and tie into the Ground side of the control without using a resistor. ------------- If i Can't Install it I Don't need it Joe
Posted By: belvedere
Date Posted: November 10, 2015 at 6:12 AM
Just what I needed -- thank you!!
|