C3-RS730 LCD wiring
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139916
Printed Date: May 16, 2024 at 9:36 AM
Topic: C3-RS730 LCD wiring
Posted By: mcculleb
Subject: C3-RS730 LCD wiring
Date Posted: December 11, 2015 at 6:14 AM
Hello
Purchase the C3-RS730 LCD and Idatalink asd-acla module. After reading all instructions, I have one question.
Do I need to run the wires to the ignition and start wires directly from the remote start, the vehicle, and to the data link module or is it only required to run the ignition and start wire from the remote start to the data link?
Thank you.
-------------
Brian McCullen
Replies:
Posted By: mcculleb
Date Posted: December 11, 2015 at 6:15 AM
Sorry, 2011 Honda CRV
-------------
Brian McCullen
Posted By: beegbie
Date Posted: December 14, 2015 at 7:29 PM
Hey Brian, you need to hook up the wires from the remote start to the car. Follow the guide for the ignition connection form the alca to the immobilizer plug and you will only need to wire the starter input from the remote start to the alca if your not in dbi mode.
The guys over at ads do not give you the remote start to car connections in this guide.
Posted By: mcculleb
Date Posted: December 14, 2015 at 8:23 PM
Thanks for the response. I understand about going from the rs to the module on the start circuit and the musical starring the vehicle via can bus. What I didn't understand was the wiring for the ignition wire. It shows on the musical that it is an input going to ignition. I'm guessing I will also have to hook up the ignition wire from the rs and the input wire on the module to the vehicle ignition wire.
-------------
Brian McCullen
Posted By: mcculleb
Date Posted: December 14, 2015 at 8:24 PM
Module, not musical. Lol... Stupid auto correct.
-------------
Brian McCullen
|