Installing an auto-headlight system from directe
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139970
Printed Date: May 11, 2025 at 11:30 PM
Topic: Installing an auto-headlight system from directe
Posted By: aykfc
Subject: Installing an auto-headlight system from directe
Date Posted: December 18, 2015 at 1:40 PM
So I found a auto-headlight system you can install for pretty cheap and I bought it. I am trying to figure out how to install it now. I posted a link to the instructions below. Since the Juke headlights are positive I need to connect two wires to the headlights and then the other wire on the relay to 12v. I am thinking of putting the unit under the hood and wiring up directly to the headlights. Any issues with doing this? I also need a 12V line. Any suggestions on where I could find one that can handle the amperage for the parking lights.
Amazon.com : Directed Electronics 545T Nite-Lite System D : Automotive Security Devices : Car Electronics
https://www.auto100.ro/specificatii-t...catii_1492.pdf
Replies:
Posted By: Mark Mizenko
Date Posted: December 18, 2015 at 10:24 PM
Don't mount it under the hood, it's not made for that. Mount it under the dash, you can get 12volts from the big white wire at the fuse box.
Posted By: aykfc
Date Posted: December 19, 2015 at 1:48 PM
Thanks! I am assuming I can't wire it directly to the parking light control switch as it sends a signal to the BCM and the BCM turns on the lights. So would I run the headlight and parking light wire through the firewall and connect it to the wire going to the headlight?
|