07 Camry Remote start install no brake lights
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139998
Printed Date: May 03, 2024 at 6:16 AM
Topic: 07 Camry Remote start install no brake lights
Posted By: justinh722
Subject: 07 Camry Remote start install no brake lights
Date Posted: December 22, 2015 at 7:20 PM
Car is a 2007 Toyota Camry SE 4 cylinder. I used an Avital 4103LX and an idatalink ADS-TB bypass module. Everything functions as it should, except for the brake lights. I've done quite a few installs and I always solder all of my connections.
I know the brake switch is working because the remote start shuts off when the brake is applied without the key in the ignition. All the bulbs are good. While checking for wires, I did blow the stop fuse. I replaced it but the problem still persists.
The guy needs his car back asap. I'm about to go out and clip the brake input wire to the remote start but I don't think that will make a difference. Anyone have any recommendations?
Replies:
Posted By: triniforever
Date Posted: December 22, 2015 at 8:49 PM
Did you check all the fuses in the car? Most likely there is another blown fuse somewhere !
-------------
triniforever
|