Print Page | Close Window

2015 toyota venza pts

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=140711
Printed Date: May 05, 2024 at 5:08 AM


Topic: 2015 toyota venza pts

Posted By: ricardoboston
Subject: 2015 toyota venza pts
Date Posted: January 23, 2016 at 6:05 AM

Hi there, I'm having trouble installing a remote starter a Toyota Venza I installed the remote starter W2W and the remote starter I'm using is a viper 4105v and the bypass is a adsalca the bypass was programmed successfully but overtime i try to start the car the car runs for 2 seconds and than the engine turns off, i tried tach wire , i tried tachless, i tried check engine off, and still the same problem. when the car starts i noticed the light on the bypass goes red when i start the car and than when the car shuts off the bypass goes green again. Then i tried d2d and the same problem. does anyone know any solution to this problem, i still have the car in the garage over here. Thanks



Replies:

Posted By: triniforever
Date Posted: January 23, 2016 at 8:46 AM
Which install guide did you use ? For you to remote start that vehicle all doors must be closed and locked. Also no takeover is available for that car when you open a door the car will shut down. List the connections you made .

-------------
triniforever




Posted By: triniforever
Date Posted: January 23, 2016 at 8:47 AM
Also did you program tach ?

-------------
triniforever




Posted By: ricardoboston
Date Posted: January 23, 2016 at 4:52 PM
hi there sorry for the delay ,I've worked on this car a lot to diagnose the problem and i did it. Nothing was wrong with my installation, the only problem was next to ECU there are 4 connectors 2 black 2 whites so when i reconnected them back i misplaced them. I put the white to the whites and blacks to the dark gray, but it's not that way, they have their own placement. so this will be a good lesson to never go by the color, especially when they fit one in the others. thanks




Posted By: ricardoboston
Date Posted: January 25, 2016 at 3:37 PM
hi there as i said i misplaced those 4 plugs and something weird happened. the costumer reported to me that there was a noise on the left side, like a relay or something trying to engage. i don't know exactly how to describe this noise and i was wondering if i still have the plugs on the wrong position so i have a pic of the plugs on my hands and another one from the toyota diagram ,i really need to figure out if they still off the place please. thanks




Posted By: ricardoboston
Date Posted: January 25, 2016 at 4:05 PM
posted_image

posted_image

posted_image




Posted By: beegbie
Date Posted: January 25, 2016 at 6:34 PM
I've worked on many Venzas and I can't discern what plugs your holding onto. Did you make any connections to the wires coming from these plugs?




Posted By: ricardoboston
Date Posted: January 25, 2016 at 9:43 PM
no i don't have nothing connected to it I'm trying to find the right position for those plugs i have them disconnected and not sure how they go back to the right spot got it?they are locate at your left side of the fuse box




Posted By: ricardoboston
Date Posted: January 26, 2016 at 4:31 PM
hi there i wish that one of these great technicians here would post a pic of a 2015 or another year toyota venza these plugs are on the left side of the fuse box
the only thing i need is to know exactly where these four plugs go in each place





Print Page | Close Window