viper 5706v False Alarm and Bitwriter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=140791
Printed Date: May 05, 2024 at 2:54 AM
Topic: viper 5706v False Alarm and Bitwriter
Posted By: dislexiksmurf
Subject: viper 5706v False Alarm and Bitwriter
Date Posted: February 03, 2016 at 7:55 PM
I have a '91 300ZX, and have installed a viper with the glass break, tilt, and shock sensors. The glassbreak has the y-connector for tapping in with the shock sensor, but my question is, why would I be getting false alarms? If the wires were supposed to be diode isolated, the installation instructions would say to do so, but they do not, when using the y-connector.
I want to change the 'optional sensors' to Glass break and tilt. Is this possible? And if this is possible, is a bitwriter needed?
I'm 99% certain the 'Viper' symbol blinking could be back feeding on the GWA wire, even though it is the only thing connected, besides the programmable voice. Even though the orange wires on each optional sensor port are seperate from the main harness GWA wire, are they tied together?
Thanks guys
|