2002 Rav4, prestige aps997e installation
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=140853
Printed Date: April 29, 2024 at 2:04 AM
Topic: 2002 Rav4, prestige aps997e installation
Posted By: skchoppala
Subject: 2002 Rav4, prestige aps997e installation
Date Posted: February 15, 2016 at 12:07 PM
Hi, I have started wiring Audiovox APS997E and struck figuring out few things. I really appreciate your help in advance
I have my car with dome light stays one few seconds or turns off as soon i lock the doors with factory key less entry. How to connect this? Install doc says "This wire provides a 30 second ground output, (300 mA Max.)" Do i have to use Relay?
Parking Lights: I have my security system provided with Parking Light Relay Input wire and Output Wire. How to make these connections with rav4 GREEN (+) as per the wiring diagram?
Ground Output While Running (-) 300mA: The mode i am trying to use is " Anti-Grind Starter Circuit Connection". The Installation manual referring to use relay. Does it really required? or rav4 starter wire will come from default relay?
Replies:
Posted By: howie ll
Date Posted: February 15, 2016 at 1:27 PM
a) Not needed your vehicle has built in dome supervision, you just described it!
b) Input must go to a 12V+ constant source.
c) Shouldn't be needed.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: skchoppala
Date Posted: February 15, 2016 at 1:41 PM
Hi howie,
Thanks for the quick replay,
My uderstanding about Anti-Grind is to stop cranking the engine through key when car is started with remote. Will it not damage the starter with out connecting this wire?
Posted By: howie ll
Date Posted: February 15, 2016 at 3:38 PM
Some vehicles have built in anti-grind, I'm not familiar with the R/Start so I suggest you contact Voxx.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: skchoppala
Date Posted: February 15, 2016 at 3:47 PM
I did through test by turning key from start to crank while engine is running... it did make a wired sound. I hope it does not have automatic grind option. any how i will check with Voxx company as you suggested. Thank you very much for your help.
Posted By: skchoppala
Date Posted: February 24, 2016 at 10:23 AM
Finally i have done with my installation and every thing works fine. Howie II thanks for your inputs. I did call customer car regarding my third question( Anti-Grind Starter Circuit Connection) and made the connection with relay provided in the kit. But i did not see its stop sending the signal to starter when the engine is started with remote. I may have to call back cust care.
|