2013 Ford Edge V6 standard key

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141037
Printed Date: May 13, 2025 at 12:01 AM

Topic: 2013 Ford Edge V6 standard key

Posted By: groundzero2010
Subject: 2013 Ford Edge V6 standard key
Date Posted: March 19, 2016 at 12:32 PM

Working with a Python 5706p and Fortin EVO-ALL

DEI's install wires have changed since I last used one. The Fortin install diagram is pretty self explanatory but trying to match up the wires Fortin is asking for to the DEI 10-pin heavy harness isn't straight forward.

Fortin is looking for:
Start
Ign2
Ign1
Acc
12V
Ground

DEI 10-pin harness:
RED / Black - Fused 12V Accessory/Starter Input
Pink/Black - Flex Relay Input 87a keyside (if req'd) of Flex Relay
Pink/White - Ign2 / Flex Relay Output
Red - 12V Ign 1 input
Green - Starter Input (Key side)
Violet - Starter output (car side)
Orange - Accessory output
RED / White - Fused 12v Ign 2 / Flex relay input 87
Pink - Igntion 1 input/output

I'm not use to the flex relay wiring that DEI has going on now. Could someone possibly help in directing me to which wires would tie together between the DEI and car (fortin diagram) unit?

Attaching an image of the actual diagram from Fortin.

posted_image

Replies:

Posted By: groundzero2010
Date Posted: March 19, 2016 at 12:41 PM

Going off the diagram I'd assume these connections:

DEI --> Car
Pink/White --> WHITE/ Orange
Red --> GREEN/ Red
Pink --> Blue/White
Orange --> PURPLE / Green
Violet --> Blue/White -Cut (car side)
Green --> Blue/White -Cut (key side)

RED / Black ??
Pink/Black ??
RED / White ??

-------------
By the way, it was brought to my attention, on your abbreviation for circuit you use "CKT". There is not "K" in circuit. Should this possibly be CCT? - R. Robson

hahahahahahaha

Posted By: smokeman1
Date Posted: March 19, 2016 at 12:49 PM

This might help:

https://www.the12volt.com/installbay/forum_posts.asp?tid=132562&tpn=1

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Posted By: groundzero2010
Date Posted: March 19, 2016 at 1:02 PM

That's a great writeup! I found my issue. RED / Black needs to be connected to 12V as to push 12V to the starter during engage. Thanks for the help!

-------------
By the way, it was brought to my attention, on your abbreviation for circuit you use "CKT". There is not "K" in circuit. Should this possibly be CCT? - R. Robson

hahahahahahaha