2001 chevy surburban, viper 4105v rs, idatalink
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141175
Printed Date: May 02, 2025 at 6:06 AM
Topic: 2001 chevy surburban, viper 4105v rs, idatalink
Posted By: wyciwug
Subject: 2001 chevy surburban, viper 4105v rs, idatalink
Date Posted: April 16, 2016 at 7:32 PM
Hello
I am about doing rs one way viper 4105v and idatalink bypass. I have a question about this. Can someone tell me what it meant and what do i need to do
? Thanks
To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system.
-------------
DCD
Replies:
Posted By: chev104275
Date Posted: April 17, 2016 at 4:40 AM
The wire must be powered like an ignition (12v through cranking). Verses accessories which is (12v drops out when cranking)
-------------
If i Can't Install it I Don't need it Joe
Posted By: wyciwug
Date Posted: April 17, 2016 at 8:21 AM
hello
Do i connect the PINK/WHITE wire from remote start to vehicle second Ignition #2: WHITE normally?
Pink wire from remote start to vehicle's Pink wire ignition #1?
Thanks
-------------
DCD
Posted By: wyciwug
Date Posted: April 17, 2016 at 11:15 AM
Got it thanks
-------------
DCD
Posted By: wyciwug
Date Posted: April 28, 2016 at 7:27 PM
hello
I got the vehicle started now but there is a problem
Customer said driver side window roll down when starting the car sometimes, not all the times
Also alarm went off sometimes when starting also. Do I connect unlock wire from remote start to alarm disarm wire in vehicle?
What is the cause of the window to roll down sometimes when remote start?
D
-------------
DCD
Posted By: chev104275
Date Posted: April 29, 2016 at 4:49 AM
Where is the disarm wire from the 4105 connected ?
-------------
If i Can't Install it I Don't need it Joe
Posted By: wyciwug
Date Posted: April 29, 2016 at 9:18 AM
I didn't use that wire. I should reuse it now right?
-------------
DCD
Posted By: chev104275
Date Posted: April 29, 2016 at 10:24 AM
if it has a factory alarm you will need it connected
Factory Alarm Disarm lt. green (driver door key cylinder) - BCM, purple plug, pin B3
Notes: The BCM (Body Control Module) is under the driver dash.
-------------
If i Can't Install it I Don't need it Joe
|