Print Page | Close Window

2016 Ford Escape door trigger n.c

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141196
Printed Date: May 12, 2025 at 4:59 AM


Topic: 2016 Ford Escape door trigger n.c

Posted By: desh187
Subject: 2016 Ford Escape door trigger n.c
Date Posted: April 23, 2016 at 11:00 AM

Installed an Omega Proline keyless upgrade alarm and used domelight wire but alarm gives false triggers even with a relay.
Now i got all the individual door pin wires which are n.c and requires two 1amp diodes and a 10k resistor in between getting 12 volts.
I installed the above but opening any door doesnt set off alarm.Now my question is,do i need to cut each door pin wire to attach diodes or just solder them on as instructions dont mention cutting and thats what i did.
Thanks for any feedback

Th



Replies:

Posted By: kreg357
Date Posted: April 24, 2016 at 7:02 AM

Here is a diagram for the necessary circuit for the NC Door Pins.

posted_image

You must cut the factory door pin wires and insert diodes as shown, ensuring correct diode band direction.



-------------
Soldering is fun!


Print Page | Close Window