unable to use aux with 535t
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141813
Printed Date: May 11, 2024 at 5:35 PM
Topic: unable to use aux with 535t
Posted By: gregory raines
Subject: unable to use aux with 535t
Date Posted: October 02, 2016 at 10:53 PM
I have a Honda Civic 2007. I just installed a 5706v in for the alarm. the alarm is functioning properly and waiting on the Bitwriter to arrive to finish out the programming. i also installed a 535t for function of my front 2 windows. i was able to run the module through the learning portion so it knows how far to vent. if my windows are down and i use my r/s the windows will roll up. when i use the aux 1 input, which is where the aux from the 535t is ran, nothing happens. i took a dmm and put the red on a constant 12v and placed the balck on the aux wire expecting there to be no reading, but when i did it showed 12v.
correct if i'm wrong but that means that the wire is receiving a neg signal already from either the module or the alarm?
i tested the other aux input wires and they didnt return a reading at all on the dmm. so i cut the wire and tested both sides and the 535t is the item that is emitting the signal. so im not sure what to do. what steps do i need to take or is my 535t faulty?
|