DEI Glass Break Sensor disables Warn Away
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=14182
Printed Date: July 14, 2025 at 6:52 PM
Topic: DEI Glass Break Sensor disables Warn Away
Posted By: street tuner 9
Subject: DEI Glass Break Sensor disables Warn Away
Date Posted: May 29, 2003 at 11:28 PM
I installed a Viper 790XV with 2 shock sensors, a proximity sensor, and a DEI Glass Break Sensor. When the microphone is plugged into the GB sensor, the Warn Away response no longer works. The alarm will trigger immediately. This applies to all sensors. However, if the microphone is unplugged, the Warn Away response is restored. I have the GB sensor soldered with one of the shock sensors as per DEI instructions. I have adjusted sensitivity on all sensors. Still the same problem. Any help would be appreciated!
Replies:
Posted By: auex
Date Posted: May 30, 2003 at 5:07 PM
Did you use diodes to isolate the sensors?
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
Posted By: djfearny2
Date Posted: May 30, 2003 at 5:21 PM
must use diodes and on the blue and or green wire from shock sensors and stuff . all this for one car is a little much........... but anyways you have to isolate all the sensors from one another. and it would be better if you gave the black wire of each a ground other than the black wire on the original shock senosr. so the only wire that should be getting ground from alarm should be the first shock sensor..,.
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
|