2013 chevy traverse, avital 4103

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141877
Printed Date: May 13, 2025 at 3:59 AM

Topic: 2013 chevy traverse, avital 4103

Posted By: ricardoboston
Subject: 2013 chevy traverse, avital 4103
Date Posted: October 17, 2016 at 9:01 PM

GUYS I'm installing a remote start avital 4103 and ads al ca on this vehicle my question is i know the bypass goes connected to ing and acc heavy gauge wires should i have to get the heavy wires connected to the car like purple start wire and ign and acc?or just do as idatalink says will handle the start, acc and ign ?thanks

Replies:

Posted By: lurch228
Date Posted: October 17, 2016 at 9:08 PM

Data controlled functions don't need to be hard wired.

Posted By: ricardoboston
Date Posted: October 18, 2016 at 6:30 AM

lurch228 hi i have already hardwire just need to know if i need to hook up the start wire purple ignition wire pink and acessory orange wire have gauges to the car ign acc start wire thanks

Posted By: lurch228
Date Posted: October 18, 2016 at 6:49 AM

Follow idatalink first. Only connect what idatalink doesn't do to R/S, then test.

Posted By: ricardoboston
Date Posted: October 18, 2016 at 7:14 AM

oh ok just one more question if the radio stays on should i pulse negative on the drivers door pin using a relay and factory alarm rearm .thanks

Posted By: lurch228
Date Posted: October 18, 2016 at 6:45 PM

If bypass doesn't support that function then yes.

Posted By: ricardoboston
Date Posted: October 18, 2016 at 7:23 PM

lurch228 thanks works just perfect

Print Page | Close Window