Tahoe 2000 auto start installation
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141961
Printed Date: May 15, 2024 at 8:01 PM
Topic: Tahoe 2000 auto start installation
Posted By: hisan0307
Subject: Tahoe 2000 auto start installation
Date Posted: November 03, 2016 at 1:25 PM
Hey guys I'm new in this forum and I hope you can help me. I'm planning to install an auto start and security alarm system in my Tahoe 2000. I bought a viper 5706v 2-way alarm and I want to know if I need any additional parts in order to work fine. also, I have been searching information about the installation process and there are different way to install. I will appreciated your help in all the advise or instruction you can give me for complete this installation. Thanks again.
Replies:
Posted By: dairyboy3
Date Posted: November 03, 2016 at 3:43 PM
Use a DBALL 2. It will take care of a few features such as door locks, door triggers, tach, hatch release, and will also take care of the passlock 2 bypass.
Posted By: kreg357
Date Posted: November 03, 2016 at 3:58 PM
If you use the DB-ALL2 suggested above, get if flashed with the proper firmware by the seller prior to shipment. If you want to do it slightly differently...
You will need a few more items to complete the install.
Your truck has the Passlock2 engine immobilizer system and needs to be bypassed during a remote start. Due to the
extreme cold weather in Alaska, I would recommend a data style bypass module rather than a resistor based unit. My
favorite is an iDatalink ADS TBSL PL. Another good choice is the Fortin INT-SL or INT-SL+. Either module will work
with your Viper in W2W mode.
Most of the necessary wires are found at the BCM just under the steering column. This truck has Type A Locks and
needs a Directed 451M Door Lock Module to change the Vipers (-) polarity lock outputs to the (+) 12V signal needed.
Here is a link to a Pictorial on the 99 - 02 Silverado : https://www.the12volt.com/installbay/forum_posts.asp?tid=135786
This vehicle is very similar to yours. The only wires not shown are the Door Pins needed for alarm system access
monitoring.
-------------
Soldering is fun!
Posted By: hisan0307
Date Posted: November 03, 2016 at 4:20 PM
Thanks for the response guys first. This probably will sound weird but my Tahoe Doesn't came with the BCM ( apparently by Chevrolet is located in the central consul) but by the Vin number doesn't have one. so I'm stuck in that part because I don't know where connect the cables going to the BCM. kreg357m, I saw those post about the Silverado before but those connection are different in my Tahoe. Thanks again guys.
Posted By: geepherder
Date Posted: November 03, 2016 at 11:13 PM
https://www.the12volt.com/installbay/alarmdetail/575.html
-------------
My ex once told me I have a perfect face for radio.
|